Aluminum and Non-Ferrous Materials

Family focused on chip evacuation and reducing built-up edge on sticky materials.

ISO: N
Geometry: D6 | R3 | Z2
Flutes: Z2
Visual finish: Polished

Z2 geometry with polished flutes. Cooling: air, MQL or emulsion depending on material and machine. Displayed example: D6 | R3 | Z2.

Applications for this family

Usage cues. Adapt to grade, machine and toolpath.

Wrought and cast aluminum
Non-ferrous alloys
3D semi-finishing and finishing
Strategies with reliable chip evacuation

Indicative starting values — tool D6, R3

Conservative starting ranges for a D6 ball nose with low to moderate radial engagement. Confirm by trial.

Confirm by trialIndicative values

ISO	Initial vc (m/min)	Initial fz (mm/tooth)	Recommended ae	Recommended ap	Cooling
N	250–500	0,025–0,060	5–15 % D	0,10–0,50 D	Air, MQL or emulsion

In ball-nose milling, effective cutting speed decreases toward the tool centre. For 3D finishing, prefer tool tilt or a toolpath that avoids continuous centre cutting.

Elegir un diámetro

Seleccione el diámetro de corte. El diámetro de mango correspondiente se aplica automáticamente según la matriz estándar Qeviora.

Serie estándar

Elegir un diámetro

Seleccione el diámetro de corte. El diámetro de mango correspondiente se aplica automáticamente según la matriz estándar Qeviora.

Diámetro de corte

Diámetro de corte: Ø1 mm
Diámetro de mango: Ø4 mm
Referencia: QCT-BN-D01-S04

Technical warning: illustrated visuals, coatings and cutting parameters are indicative only. They are not a performance guarantee, a commercial equivalence with another manufacturer, or final validation without machine trials.