Aluminum and Non-Ferrous Materials

Family focused on chip evacuation and reducing built-up edge on sticky materials.

ISO: N
Geometry: D6 | R3 | Z2
Flutes: Z2
Visual finish: Polished

Z2 geometry with polished flutes. Cooling: air, MQL or emulsion depending on material and machine. Displayed example: D6 | R3 | Z2.

Applications for this family

Usage cues. Adapt to grade, machine and toolpath.

Wrought and cast aluminum
Non-ferrous alloys
3D semi-finishing and finishing
Strategies with reliable chip evacuation

Indicative starting values — tool D6, R3

Conservative starting ranges for a D6 ball nose with low to moderate radial engagement. Confirm by trial.

Confirm by trialIndicative values

ISO	Initial vc (m/min)	Initial fz (mm/tooth)	Recommended ae	Recommended ap	Cooling
N	250–500	0,025–0,060	5–15 % D	0,10–0,50 D	Air, MQL or emulsion

In ball-nose milling, effective cutting speed decreases toward the tool centre. For 3D finishing, prefer tool tilt or a toolpath that avoids continuous centre cutting.

Durchmesser wählen

Wählen Sie den Schneiddurchmesser. Der passende Schaftdurchmesser wird automatisch gemäß der Qeviora-Standardmatrix gesetzt.

Standardreihe

Durchmesser wählen

Wählen Sie den Schneiddurchmesser. Der passende Schaftdurchmesser wird automatisch gemäß der Qeviora-Standardmatrix gesetzt.

Schneiddurchmesser

Schneiddurchmesser: Ø1 mm
Schaftdurchmesser: Ø4 mm
Referenz: QCT-BN-D01-S04

Technical warning: illustrated visuals, coatings and cutting parameters are indicative only. They are not a performance guarantee, a commercial equivalence with another manufacturer, or final validation without machine trials.